Repair manual

Burner Setup Cub 200/300
26 ghi_tx001317gb.fm
Continued from the previous page.
9. Adjust the fuel pressure, if necessary, using the adjusting screw (e).
NOTICE: Do not adjust the fuel pressure outside of the parameters listed in the
Technical Data charts.
10.Restart the machine and check the gauge.
11.Repeat steps 7–9 as necessary until the pressure is correct.
12.Remove the pressure gauge (d) from the pressure test port.
13.Reinstall the threaded plug (b) into the pressure test port.
14.Close the access panel and reinstall the two bolts that secure it.