Repair manual

Cub 200/300 Burner Setup

ghi_tx001317gb.fm 25

3.7 Checking and Adjusting the Fuel Pressure

Requirements

 Pressure gauge

 British Parallel Thread (BPT) adapter

Procedure

To check and/or adjust the fuel pressure, carry out the following procedure:

1. Shut down the machine and allow it to cool.

2. Disconnect the power cord from the power source.

3. Open the access panel (a).

4. Remove the threaded plug (b) from the pressure test port using an allen

wrench. Set the plug in a safe location to be re-installed later.

5. Install a pressure gauge with BPT adapter (d) in the pressure test port.

6. Reconnect the power source.

7. Start the machine. With the machine running and access panel closed, observe

the fuel pressure on the gauge (c). For the correct pressure, refer to the

Technical Data charts in this manual.

8. Shut down the machine.

This procedure continues on the next page.

ghi_gr006919