Repair manual

Burner Setup Cub 200/300
22 ghi_tx001317gb.fm
3.4 Checking and Adjusting the Burner Electrodes
Requirements Burner assembly removed
Background Inspect the electrodes for the following:
 Wear
Be sure to inspect the ends of the electrodes for pitting. Replace any worn elec-
trodes.
 Straightness
Replace any bent or broken electrodes.
 Cleanliness
Clean the electrodes with a soft dry cloth or replace if necessary.
 Correct alignment
Align the electrodes as shown.
Procedure Perform the procedure to replace or align the electrodes.
1. Remove the burner assembly from the machine.
2. Loosen the screw (1).
3. Align the electrode as shown or remove and install new electrodes if necessary.
4. Tighten the screw (1).
5. Reinstall the burner.
Result The electrodes have now been adjusted.