Repair manual

Cub 200/300 Burner Setup
ghi_tx001317gb.fm 21
3.3 Removing and Installing the Burner Assembly
Background Before performing any maintenance on the burner assembly, it must be removed
from the machine.
Removal To remove or install the burner assembly perform the following procedure:
1. Shut down the machine and allow it to cool.
2. Disconnect the power cord from the power supply.
3. Remove the two bolts and open the access panel (a).
4. Rotate the burner assembly (b) counterclockwise and remove it from the flame
head and air tube assembly (e).
Installation Perform the procedure below to install the burner assembly.
1. Place the burner assembly (b) into the flame head and air tube assembly (e).
2. Rotate the burner assembly clockwise to lock it into place.
3. Close the access panel (a) and re-install the two bolts that secure it.