Operator`s manual

HI 110 / 200 / 300 Maintenance

ghi_tx001450gb.fm 47

7.4 Cleaning the Fan Blades and Motor

Prerequisites

 Machine shut down and cool to the touch

 Power source disconnected

When

Clean the fan blades and motor prior to the first seasonal use, every 1200 hours or

annually, or as needed.

To clean the fan blades and motor, carry out the following procedure.

1. Remove the fan guard (f). There are four screws that secure the fan guard.

2. Remove the the access panel (g). See topic Removing the Access Panel.

This procedure continues on the next page.

WARNING

Electric shock hazard. Electric power is still active at the blower even when the

machine is turned OFF.

f Remove all electric power to the machine before performing this procedure.

CAUTION

Hot surface hazard. The machine surfaces may be hot.

f Allow the machine to cool for a minimum of ten minutes before touching it.

ghi_gr007380

HI 110D HI 200 / HI 300