Operator`s manual

Operation HI 110 / 200 / 300
28 ghi_tx001447gb.fm
4.9 Installing the Heater Duct
Overview Optional ducts can be connected to the air outlet. This allows warm air to be evenly
distributed throughout the heating area.
NOTICE: When using ducts, observe the static air pressure limits specified in
Technical Data.
Requirements  Machine shut down and cooled
 Machine properly positioned
Procedure To install the ducts, carry out the following procedure.
1. Open the clamps (a).
2. Slide the duct (b) onto the duct adapter (c).
3. Close the clamp to secure the duct in place.
CAUTION
Hot surface hazard. The machine surfaces may be hot.
f Allow the machine to cool for a minimum of ten minutes before touching it.