Repair manual

Engine CRT Repair
wc_tx000097gb.fm 80
Installation:
8.2.22 Lift and slide the engine into the frame of the machine, using the lift
brackets (m).
8.2.23 Apply Loctite 243 to the screws and install the 3 shockmount nuts into
the front and side of the engine base. Torque to 25 Nm (18 ft.lbs.)
8.2.24 Install the universal joints and shims (if removed) to ends of drive shaft.
Install the 4 bolts holding each inside universal joint to the shaft fitting.
Torque to 17 Nm (12 ft.lbs.).
8.2.25 Attach battery positive cable (k) and stater wire (l).
8.2.26 Connect ground cable to right side of engine.
8.2.27 Replace tie wraps as needed.
8.2.28 Connect the temperature sender wire (i).
8.2.29 Connect the throttle and choke cable (h).
8.2.30 Connect the fuel line (g) at the carburetor. Attach clamp to radiator
shroud that holds the fuel line.
8.2.31 Plug in the alternator sensor (f).
8.2.32 Plug in the alternator control wire (e).
8.2.33 Attach the alternator output cable (d).
8.2.34 Plug in the anti-backfire solenoid (c).
8.2.35 Plug in the oil pressure switch (b).
8.2.36 Plug in the 6 ignition secondary wires (a).
8.2.37 Apply Loctite 243 to bolts and install cross brace. Torque to 25 Nm (18
ft.lbs.).
8.2.38 Lift trowel.
8.2.39 Apply Loctite 243 to the screws and install the remaining 2
shockmounts located under the engine. Torque to 25 Nm (18 ft.lbs.).
While trowel is lifted install the 6 bolts holding on the splash pan.
Torque to 25 Nm (18 ft.lbs.).
8.2.40 Set trowel down on a flat surface.
8.2.41 Open fuel valve on fuel tank.
8.2.42 Connect battery.