Repair manual

CRT Repair Engine
wc_tx000097gb.fm 79
8.2 Engine Removal and Installation-Vanguard Engine
See Graphic: wc_gr002079
Removal:
8.2.1 Disconnect battery.
8.2.2 Lift trowel. Attach a slings or chains through the lifting bars on each
side of the seat pedestal.
CAUTION: Make sure the lifting device has enough weight bearing
capacity to lift machine safely. Refer to Section Technical Data.
DO NOT lift the trowel by the guard rings or any part of the trowel other
than the lifting fixture, as the component may fail, causing the trowel to
fall, possibly injuring bystanders.
8.2.3 While trowel is lifted remove the 6 bolts holding on the splash pan.
Remove only the two shockmount nuts located under the engine.
8.2.4 Set trowel down on a flat surface.
8.2.5 Remove 2 bolts and remove cross brace.
8.2.6 Close fuel valve on fuel tank.
8.2.7 Unplug the 6 ignition secondary wires (a).
8.2.8 Unplug the oil pressure switch (b).
8.2.9 Unplug the anti-backfire solenoid (c).
8.2.10 Unplug the alternator output cable (d).
8.2.11 Unplug the alternator control wire (e).
8.2.12 Unplug the alternator sensor (f).
8.2.13 Disconnect the fuel line (g) at the carburetor. Remove clamp from
radiator shroud that holds the fuel line.
8.2.14 Disconnect the throttle and choke cables (h).
8.2.15 Unplug the temperature sender wire (i).
8.2.16 Cut tie wraps as needed.
8.2.17 Disconnect ground cable from right side of engine.
8.2.18 Remove battery positive cable (k) and stater wire (l).
8.2.19 Remove the 4 bolts holding each inside universal joint to the shaft
fitting. Remove universal joints and shims (if included) from ends of
drive shaft.
8.2.20 Remove the remaining 3 shockmount nuts from the front and side of
the engine base.
8.2.21 Lift and slide the engine back, using the lift brackets (m).
WARNING