Repair manual

Steering and Pitch Control CRT Repair
wc_tx000096gb.fm 52
7.4 Removal and Installation of Electric Steering Load Pins
See Graphic: wc_gr002280
Removal:
7.4.1 Turn ignition switch to the OFF position.
7.4.2 Trowel should be on a flat surface with the blades pitched flat.
7.4.3 Flip seat assembly forward. Make sure seat lock engages.
7.4.4 For the rear actuator (left/right steering), remove the protective cover
(a).
7.4.5 Disconnect the load pin wiring connector (b).
7.4.6 Using snap ring pliers, remove the load pin retaining snap ring (c) from
the shaft.
7.4.7 Support the actuator motor and carefully remove the load pin (d).
Secure the actuator motor to prevent damage.
Installation:
7.4.8 Align actuator motor mounting hole and carefully insert the load pin (d).
7.4.9 Rotate load pin (d) so the smaller alignment flat engages the locking
plate (k).
7.4.10 Install load pin retaining snap ring (c). Make sure the snap ring is fully
engaged into the shaft groove. Check load pin for movement. It should
NOT move in or out.
7.4.11 Connect load pin wiring connector (b).
7.4.12 Install protective cover (a) on rear actuator, if removed.
7.4.13 Lower seat assembly.