Repair manual

Steering and Pitch Control CRT Repair
wc_tx000096gb.fm 46
7.1.15 Center the steering handles. The left pivot bracket (v) must be in a
horizontal position when the machine is at rest. This link attaches to
the gearbox pivot and the left pivot bracket (v). To adjust, loosen the
jam nuts on the left/right pivot link (u) and turn until the left pivot bracket
(v) is horizontal. Torque the nuts to 75 Nm (55 ft.lbs.). If steering
handles are not centered, loosen the nuts on the offset pivot link (w)
and remove the bolt (d) from the bottom of the steering handle. Turn
the handle mounts (c) until the steering handles are centered. Reinstall
the bolt (d) into the bottom of the steering handle. Torque the jam nuts
on the offset pivot link (w) to 75 Nm (55 ft.lbs.).
7.1.16 Adjust steering handle spacing. Loosen the jam nuts on the handle
pivot link (x). Loosen the bolts (d, e) from the bottom of the steering
handles. Turn the handles in or out to increase or decrease to the width
preferred by the operator. Torque the jam nuts and bolts to 75 Nm (55
ft.lbs.).
7.1.17 Adjust forward and reverse movement. The forward/reverse steering
pivots (r) must be in a horizontal position when the machine is at rest.
Loosen the jam nuts on the pivot links (q and y). Turn the links in or
out to level the steering pivots. Torque the jam nuts to 77 Nm (57
ft.lbs.).
7.1.18 Attach front grill panel with 4 screws and plug in water pump.