Repair manual

CRT Repair Gearbox and Spider
wc_tx000095gb.fm 41
6.4.22 Using a combination square, place the end of the blade on the flat
surface (2).
6.4.23 With the combination square’s blade against the front (raised) edge of
the trowel blade, move the sliding portion down to the top of the trowel
blade and lock it in place.
6.4.24 Check each blade against this measurement.
6.4.25 If adjustment is needed, remove shoulder bolt (w) and turn link (qq) in
to increase or out to decrease blade angle.
Note: All blades must be set at the same angle for correct operation.
6.4.26 Once all blade angles have been set, apply Loctite 243 or equivalent
to shoulder bolt threads and tighten bolts.
wc_
g
r002447
(1)
(2)