Repair manual

Drive Line CRT Repair
wc_tx000094gb.fm 30
5. Drive Line
5.1 Belt Replacement
See Graphic: wc_gr 000152
To replace the drive belt:
5.1.1 Place the trowel on a flat, level surface with the blades pitched flat.
5.1.2 Disconnect battery.
5.1.3 Remove the beltguard.
Honda / Kohler:
Remove bolts holding guard in place.
Vanguard:
Remove two bolts holding base of air cleaner to beltguard. Remove
two bolts holding beltguard to engine.
5.1.4 Remove 2 bolts (d), washers (e) and nuts (f) from each bearing flange.
5.1.5 Remove the 4 bolts (b) holding each inside universal joint to the shaft
fitting. Remove universal joints and shims (if included) from ends of
drive shaft.
5.1.6 Lift the drive pulley up far enough to slide belt past.
5.1.7 Remove the old belt and install a new one.
5.1.8 Reverse the procedure for assembly. Align the bearings and shaft as
straight as possible. Adjust pulley offset and center distance to values
as shown.
5.1.9 Torque the bearing bolts (d) to 99±10 ft.lbs. Torque the universal joint
bolts (b) to 10±1 ft.lbs.