Repair manual

CRT Repair General
wc_tx000093gb.fm 27
4.6 Wheel Kit - 0154750
See Graphic: wc_gr002301
Assembling Wheel Kit Components:
4.6.1 Bolt the wheels (a) to the brackets (b) using screws (c), washers (d),
and nuts (e) provided. The rigid wheels should be attached
perpendicular to the brackets.
4.6.2 Attach pins (f) to lanyards (g) and jacks (l).
4.6.3 Bolt lanyards to the brackets using screws (h), washers (j), and nuts
(k) provided.
Raising the CRT:
4.6.4 Insert a screw jack into the square socket in the front of the CRT. Insert
the pin into the bottom of the mount.
CAUTION: Be sure pin is in place before continuing.
4.6.5 Insert a jack into the square socket on the back of the CRT. Insert the
pin into the top of the mount.
CAUTION: Be sure pin is in place before continuing.
4.6.6 Crank the jack handles to raise the CRT.
4.6.7 Insert the wheel assemblies into the front CRT fork pockets. Use one
swivel and one rigid wheel. Insert the pins into the outer holes on the
brackets.
CAUTION: Be sure pins are in place before continuing.
4.6.8 Insert the wheel assemblies into the rear CRT fork pockets. Place the
swivel caster toward the same end of the machine as in the front. Insert
the pins into the inner holes on the brackets.
CAUTION: Be sure pins are in place before continuing.
4.6.9 Lower the jacks so the weight rests on the wheels.
4.6.10 Unpin and remove the jacks.
Lowering the CRT:
4.6.11 Insert a screw jack into the square socket in the front of the CRT. Insert
the pin into the bottom of the mount.
CAUTION: Be sure pin is in place before continuing.
4.6.12 Insert a jack into the square socket on the back of the CRT. Insert the
pin into the top of the mount.
CAUTION: Be sure pin is in place before continuing.
4.6.13 Crank the jack handles to raise the CRT.
4.6.14 Unpin and remove the wheel assemblies from the CRT.
4.6.15 Lower the jacks so the weight rests on ground.
4.6.16 Unpin and remove the jacks.
CAUTION: Do not operate trowel with jacks installed.