Repair manual

CRT Repair General
wc_tx000093gb.fm 25
4.5 Wheel Kit - 0150397
See Graphic: wc_gr002302
Assembling Wheel Kit Components:
4.5.1 Bolt the wheels (b) to the tube assemblies (a) using screws (c),
washers (d), and nuts (e) provided. The rigid wheels should be
attached perpendicular to the tube assemblies. The lock pin on the
swivel casters should be perpendicular to the tube assemblies when
attached.
4.5.2 Insert one handle (g) into the other handle (g).
4.5.3 Align the holes.
4.5.4 Insert the screw (h) and tighten the nut (j).
Raising the CRT:
4.5.5 Insert the wheel assemblies into the CRT fork lift pockets. Make sure
the two swivel casters are toward the same end of the machine.
4.5.6 Insert the retaining pins (f) into the wheel assemblies.
CAUTION: Be sure the retaining pins (f) are in place before continuing.
4.5.7 Lock the swivel casters so that the wheels are in the same direction as
the rigid casters.
4.5.8 Pivot each wheel bracket towards the closer end of the machine. If
necessary, unlock the brackets by pulling on the spring pin and
pivoting the wheel. The wheels should lock approximately parallel to
the ground.
4.5.9 Insert the handle into the tube on one of the wheels.
4.5.10 Unlock the bracket by pulling on the spring pin and use the handle to
pivot the bracket and raise the machine until the spring pin locks with
the wheel in an upright position.
4.5.11 Repeat last two steps on the other three wheels. It is easiest to do both
wheels on the same end of the machine first.
CAUTION: If there is weight on a wheel, it will pivot the wheel and
handle, therefore firmly grip the handle.
4.5.12 Unlock the swivel casters.
4.5.13 Do not push on pitch posts during transport. Lift up on CRT to assist in
turning.
Lowering the CRT:
4.5.14 Lock the swivel casters so that the wheels are in the same direction as
the rigid casters.
4.5.15 Insert the handle into the tube on one of the wheel brackets.
4.5.16 Unlock the wheel by pulling on the spring pin and pivoting the wheel.