Repair manual

Steering and Pitch Control CRT Repair
wc_tx000584gb.fm 72
7.2 Removing and Installing the Manual Steering System—CRT 36
See Graphic: wc_gr003443
Removal:
7.2.1 Turn off the machine and disconnect the battery.
7.2.2 Unplug the wiring harness (a).
7.2.3 Remove the bolts (b) securing the steering levers (d) to the handle
mounts (c) and remove the steering levers.
7.2.4 Remove the screws from the front grill and remove the front grill.
Note: On some models you will need to disconnect the water pump
before removing the front grill.
7.2.5 Remove the bolts (d, e) and the spacers (f) from the bottom of each
handle mount (c).
7.2.6 Remove the nuts (z) and remove each handle mount.
7.2.7 Remove the bolt (g) and the nut (h) from each pivot bracket (i) on the
end of the control shafts (aa).
7.2.8 Remove the screws (j) and nuts (k) securing the outside bearings (l)
to the frame and remove the outside bearings and the control shafts.
7.2.9 Remove the screws (m) and the nuts (n) from the center bearings (o)
and remove the center bearings.
Installation:
7.2.10 Grease the center bearings (o) and attach with screws (m) and nuts
(n). Torque the screws to 24 Nm (18 ft.lbs.).
7.2.11 Install one side of the control shaft into the center bearings, then
secure the other end by attaching the outside bearings (l) with screws
(j) and nuts (k). Torque the screws to 24 Nm (18 ft.lbs.).
7.2.12 Secure the control shaft to the pivot link (q) with bolt (g) and nut (h) at
pivot bracket (i).
7.2.13 Secure the handle mounts (c) to the control shafts with nuts (z).
7.2.14 Attach each steering lever (d) to the handle mounts with bolts (d, e)
and spacers (f).
7.2.15 Reconnect the wiring harness (a).
7.2.16 Attach the front grill and reconnect the water pump if it was
disconnected.