Repair manual

CRT Repair Steering and Pitch Control

wc_tx000584gb.fm 71

7.1.16 Apply Loctite 243 or an equivalent to the screws (a) and install the pitch

control tube labeled “L” on the left-side gearbox pivot and the pitch

control tube labeled “R” on the right-side gearbox pivot. Torque the

screws to 25 Nm (18 ft.lbs.).

Note: Left and Right are defined from the operator’s position.

7.1.17 Insert the threaded end of the pitch cable into the pitch cable mount (l).

With the handle cranked to the lowest position and the blades flat (0°

pitch), lift the yoke (m) until it contacts the rollers. Then, thread on the

locknut (t) until it contacts the pitch cable mount (l).

7.1.18 Be sure that the blades are flat and all slack is removed from the cable.

wc_gr001585