Repair manual

Maintenance CRT Repair

wc_tx000581gb.fm 44

4.12 Engine Oil—CRT 36

See Graphic: wc_gr000155

Drain oil while engine is still warm.

4.12.1 Remove oil fill cap (a) and drain plug (b) to drain oil.

Note: In the interests of environmental protection, place a plastic sheet

and a container under the machine to collect any liquid which drains

off. Dispose of this liquid in accordance with environmental protection

legislation.

4.12.2 Install drain plug and tighten.

4.12.3 Fill engine crankcase with recommended oil to the upper limit mark on

the dipstick (c).

Oil capacity: 1.18 l (1.25 qt.).

4.12.4 Install oil fill cap and dipstick securely.

4.12.5 To replace the oil filter, remove the installed oil filter after oil has been

drained. Apply a thin coat of oil to the rubber gasket of the replacement

oil filter. Screw the filter on until it just contacts the filter adapter, then

turn it an additional 22.24mm (7/8in) turn. Refill with oil as described

above.

wc_gr000155