Repair manual

Engine Troubleshooting and Replacement CRT Repair
wc_tx000585gb.fm 150
8.17 Installing the Vanguard Engine
See Graphic: wc_gr003428
This procedure requires a lift or crane capable of lifting 136 kgs. (300
lbs.).
8.17.1 Using an appropriate lift or crane, lower the engine (n) into the
machine.
8.17.2 Secure the engine to the cradle with the screws (k) on each side of the
engine. Install the radiator brackets (l) if removed. Tighten the muffler
(m) at the manifold if loosened during engine removal.
8.17.3 Connect the temperature sender wire.
8.17.4 Connect the throttle (i) and choke cable (j).
8.17.5 Connect the fuel line (h) at the carburetor.
8.17.6 Connect the wiring at the connector (g).
8.17.7 Connect the wiring to the starter motor and the starter solenoid (f).
8.17.8 Connect the wiring to the alternator (e).
8.17.9 Connect the anti-backfire solenoid (d).
8.17.10 Connect the oil pressure switch (c).
8.17.11 Connect the wires to the ignition modules (b).
8.17.12 Secure all the wiring with tie wraps as needed.
8.17.13 Secure the cross brace (a).
8.17.14 Install the drive belt. See section Belt Replacement.