Repair manual

Engine Troubleshooting and Replacement CRT Repair
wc_tx000585gb.fm 144
8.14 Removing the Honda Engine
See Graphic: wc_gr003431
This procedure requires a lift or crane capable of lifting 136 kgs. (300
lbs.).
8.14.1 Position the trowel on a flat surface.
8.14.2 Disconnect the battery.
8.14.3 Remove the drive belt. See section Belt Replacement.
8.14.4 Close the fuel valve on the fuel tank.
8.14.5 Disconnect the fuel hose (a) from the fuel filter.
8.14.6 Remove the screws that secure the cross brace (b) and remove the
cross brace.
8.14.7 Disconnect the wiring from the starter motor (c).
8.14.8 Cut the tie wraps, and disconnect the relays from the engine (d).
8.14.9 Remove the screw (e) and remove the ground wires from the engine.
8.14.10 Disconnect the throttle (f) and choke cable (g).
8.14.11 Disconnect the three wires of the oil pressure switch harness (h).
8.14.12 Remove the engine mounting bolts from underneath the machine.
When removing the engine mounting bolts also remove the battery
ground cable from the engine.
8.14.13 Using an appropriate lift or crane, lift the engine from the machine.