Repair manual

Steering and Pitch Control CRT Repair
wc_tx000584gb.fm 126
7.29 Removal and Installation of Joysticks
See Graphic: wc_gr003447
Removal:
7.29.1 Disconnect the battery.
7.29.2 Remove the screws (a) that secure the joystick assembly to the
machine and lift the joystick assembly off. Note: The joystick will still
be connected to the machine by the wiring harness (b).
7.29.3 Unplug the wiring harness from the joystick.
7.29.4 Remove the screws (c), washers, and nuts that secure the joystick in
the housing.
7.29.5 Lower the joystick (d) and the backing plate (e) from the housing.
Installation:
7.29.6 Position the backing plate (e) onto the joystick (d).
7.29.7 Insert the joystick into the housing from underneath the housing. Insert
the screws (c) with washers into the top of the housing and through the
backing plate. Install the locknuts and tighten.
7.29.8 Carefully connect the wiring harness (b) to the joystick.
7.29.9 Lower the joystick assembly onto the mount. Apply Loctite 243 or an
equivalent to the screws and install.
7.29.10 Reconnect the battery. Turn the key switch to the ON position and
check the function of the joystick.