Repair manual

Steering and Pitch Control CRT Repair
wc_tx000584gb.fm 122
7.27 Removal and Installation of Actuator Load Pins
See Graphic: wc_gr003445
Removal:
7.27.1 Turn the key switch to the OFF position.
7.27.2 The trowel should be on a flat surface with the blades pitched flat.
7.27.3 For the rear actuator (left/right steering), remove the protective cover
(a).
7.27.4 Disconnect the load pin wiring connector (b).
7.27.5 Remove the retaining ring (c) from the shaft.
7.27.6 Support the actuator and carefully remove the load pin (d). To prevent
damage to the actuator, secure it in the upright position.
Installation:
7.27.7 Rotate the load pin (d) so the alignment flat will engage the locking
plate (e). Align the mounting hole of the actuator with the frame and
carefully insert the load pin (d).
7.27.8 Install the retaining ring (c). Make sure the retaining ring is fully
engaged into the shaft groove.
7.27.9 Reconnect the load pin wiring connector (b).
7.27.10 Install the protective cover (a) on the rear actuator if it was removed.