Repair manual

CRT Repair Steering and Pitch Control

wc_tx000584gb.fm 115

7.23.3 Check for voltage at terminal #7 of the P1 control board connector. To

do so, turn the ignition switch ON, connect the black lead of a

multimeter to a common ground, and back probe the #7 terminal of the

P1 connector with the red lead of the multimeter. With the left joystick

in the centered position, the multimeter should read approximately 5

Volts.

• If no voltage is measured, the control board has failed; replace it.

• If voltage is measured,continue.

7.23.4 Check for feedback voltage at terminal #8 of the P1 control board

connector. To do so, turn the ignition switch ON, connect the black

lead of the multimeter to a common ground, and back probe the #8

terminal of the P1 connector with the red lead. With the left joystick in

the centered position, approximately 2.5 Volts should be measured.

• If no voltage is measured, the left joystick has failed; replace it.

• If proper voltage is measured, continue.

wc_gr003408

wc_gr003409