Repair manual

CRT Repair Steering and Pitch Control

wc_tx000584gb.fm 111

7.22.3 Check for voltage at terminal #2 of the P1 control board connector. To

do so, turn the ignition switch ON, connect the black lead of a

multimeter to a common ground, and back probe the #2 terminal of the

P1 connector with the red lead of the multimeter. With the right joystick

in the centered position, approximately 5.0 Volts should be measured.

• If no voltage is measured, the control board has failed; replace it.

• If the proper voltage is measured, continue.

7.22.4 Check the feedback voltage at terminal #3 of the P1 control board

connector. To do so, turn the ignition switch ON, connect the black

lead of the multimeter to a common ground, and back probe the #3

terminal of the P1 connector with the red lead. With the right joystick in

the centered position, approximately 2.5 Volts should be measured.

• If no voltage is measured, the right joystick has failed; replace it.

• If the proper voltage is measured, continue.

wc_gr003400

wc_gr003401