Repair manual

Steering and Pitch Control CRT Repair

wc_tx000584gb.fm 108

7.21.3 Check for voltage at the P1 control board connector. To do so, turn the

ignition switch ON, connect the black lead of a multimeter to a common

ground, and back probe the #2 terminal of the P1 connector with the

red lead of the multimeter.The multimeter should read 5.0±0.2 Volts.

• If no voltage is measured, the control board has failed; replace it.

• If voltage is measured,continue.

7.21.4 Check for feedback voltage (forward and reverse operation) from the

joystick at the P1 control board connector. To do so, turn the ignition

switch ON, connect the black lead of the multimeter to a common

ground, and back probe the #3 terminal of the P1 connector. With the

right joystick in the centered position, 2.5±0.2 Volts should be

measured.

• If no voltage is measured, the right joystick has failed; replace it.

• If proper voltage is measured, continue.

wc_

r003400

wc_gr003401