Repair manual

10 Maintenance
96 Carburetor setting
10.5 Carburetor setting
1. To make the basic setting, carefully turn the idle jet "L" inward as far as it goes.
Screw the "L" jet outward according to the following table.
2. To make the basic setting, carefully turn the idle jet "H" inward as far as it goes.
Then screw the "H" jet outward according to the following table.
3. Use the stop screw "S" for the choke to set the engine's idle speed.
4. The cutting disc rotates: Screw the "S" screw outward.
5. Engines goes out: Turn "S" inward.
.