Repair manual

10 Maintenance
94 Replacing the V-belt
10.3 Replacing the V-belt
• Loosen the nuts (3).
• Loosen the tension screw (1) (counterclockwise) until you see the screw end
(2) in the gap.
• Unscrew the nuts (3) and remove the cap (4).
• Unscrews the screws (5) and (7) and take off the side brace (6).
Note: Screw (5) is longer than screws (7). Observe the installation position
during assembly!
• Loosen the screws (8) and take off the crankcase cover (9).
• Remove the old V-belt (10) or any leftover V-belt material. Clean the inside
of the transmission with a small brush.
• Insert the new V-belt.
Note: Mount the crankcase cover (9), the side brace (6), and the cover (4) in
the reverse order.