Repair manual

10 Maintenance
91 Maintenance schedule
10 Maintenance
10.1 Maintenance schedule
Users of cut-off saws are only permitted to carry out the maintenance and care proce-
dures outlined in this repair manual. All other procedures may only be carried out by a
Wacker service station.
Component Maintenance work
Maintenance
interval
Entire cut-off saw Clean the outside and check for damage. If damage is
discovered, have it repair by qualified personnel imme-
diately
General instruc-
tions
Cutting disc, clutch Check on a regular basis for signs of damage and wear
Protective hood Clean, check position
Cutting disc Check for damage and whether the correct cutting disc
is mounted for the application at hand
Each time before
startup
V-belt Check the V-belt tension
Multifunction switch,
safety lock button,
throttle lever
Functional check
Fuel cap Check for leakage
Prefilter Clean (replace after every 20 hours of operation) Daily
Idle speed Check (cutting disc must not rotate)
Starter housing Clean to ensure a proper flow of cooling air Weekly
Starter rope Check for damage
V-belt Check for signs of damage and wear
Air filter cartridge Clean (replace after every 100 hours of operation)
Spark plug Check and replace as needed
Muffler Check it is clogged, check that the screws are tight
Suction head Replace Quarterly
Fuel tank Clean Quarterly
Bearing, clutch drum Clean and regrease Quarterly