Repair manual

8 Assembly

88 Cover/Handle

1. Screw on the bushing (12) and the pulleys (13) to the foot (16) using the Torx

screw (14).

2. Fasten the handle (1) and foot (10 or 16) with Torx screw (11).

3. Fasten the side brace (7) with Torx screw (8,9).

4. Tighten the Torx screws (11,8,9) (torque wrench setting 7 ± 0.5 Nm).

5. After you mount the cutting attachment (see 8.1), attach it to the unit and tighten

the nuts (5) by hand.

6. Screw in the tension screw (3) until the square nut (6) is flush with the marking

(x) on the hood.

7. Tighten the nuts to 20 Nm.