Repair manual

8 Assembly

84 Clutch

1. Attach the snap ring (8) in the groove of the crankshaft.

2. Attach the stopping ring (18) with recess to the snap ring (8) and disc (17).

3. Grease the needle sleeve (10) with multipurpose grease.

4. Press the needle sleeve (10) into the clutch drum (9).

5. Press the guide disc (11) into the receptacle of the clutch drum (9).

6. Block the piston with piston stop wedge (0117571) in the exhaust port of the cyl-

inder (x).

7. Press the clutch drum (9) onto the crankshaft.

8. Tighten the clutch (12) with installation wrench (0117574) and ring wrench

(19 mm) (torque wrench setting 55 ± 0.2 Nm).

Note: Left hand thread

0117571

0117574