Repair manual

8 Assembly

81 Recoil starter

7. Pass the rope through the recess (x) on the rope drum (5) and, together with the

rope, turn the rope drum (5) twice in the direction of the arrow.

8. Hold the rope drum (5) firmly with your left hand, untwist the rope (13) with your

right hand, pull the rope (13) taut and hold it tightly.

9. Carefully release the rope drum (5). The spring tension will cause the rope drum

(5) to wind up the rope (13).

10. Repeat the procedure three times. The starter handle (1) must now be in the up-

right position on the starter housing (3).

Note: When the starter rope has been fully extended, it must be possible to

continue turning the rope drum at least a quarter of a turn against the

spring tension.

Note: Hold the extended starter handle (1) securely. It will recoil quickly if you

accidentally let go of the rope drum (5).

11. Screw the air horn (6) to the starter housing (3) with the Torx tapping screws (11).

12. When you put on the starter housing (3) on the unit, pull the starter handle (1)

slightly until the starting mechanism catches.

13. Screw on the starter completely with the Torx screws (2).