Repair manual

8 Assembly
80 Recoil starter
1. Apply bonding compound to the bolt (9).
2. Press the bolt (9) with springs far enough to create a gap of 0.15 - 0.20 mm be-
tween the starter ratchet (7) and bolt (9). Attach the springs.
3. Apply a light coat of multipurpose grease to the new return spring (4) before you
install it in the starter housing (3). Insert the return spring (4) and press gently
against it so that the tabs (y) snap into the holders. Do not grease the rope drum
(5) and journals (z)!
4. Screw in the Torx tapping screws (12) and tighten only slightly.
5. Pass the starter rope (13) through the rope drum (5), the starter housing (3) as
well as the starter handle (1) with the spring washer (14). Knot both ends of the
starter rope.
Note: The knot or the starter rope end must not extend beyond the surface
of the starter handle (1).
6. When inserting the rope drum (5) in the starter housing (3), turn it slightly until
you feel the spring lock into place. Mount the V-ring (10).
5
10
y
z
12
1
3
13 1 14