Repair manual

8 Assembly

75 Ignition system module/intake manifold

10. Screw the carburetor (17) onto the intake manifold (16) (torque wrench setting

1.5 ± 0.5 Nm).

11. Connect the suction hose (15) to the intake manifold (16).

12. Slide the hose clamp (14) over the suction hose (15).

13. Place the intake manifold (16) into the tank enclosure.

14. Attach the suction hose (15) onto the cylinder (13) and fasten with the hose

clamp (14).

15. Screw the spark plug into the cylinder (13) and tighten it.

16. Set the hood (2) onto the cylinder (13) and tighten firmly with the screws (5).

17. Screw in the screw (3) with the ground cable (4).

18. Lay the ignition cable and short circuit cable (10,1) into the holder (z) of the hood

(2).

Note: For safety reasons, you should lay the short circuit cable (1) under the

ignition cable (10) into the holder.