Repair manual

8 Assembly

68 Cylinder/Crankshaft

Note: The exposed side of the ball bearing (8) faces the crankshaft. Apply

Omnifit 100M to the ball bearings on the outer ring before you insert

them in the crankcase (CS, MS).

1. Press the ball bearing (8) onto the crankshaft (10).

2. Heat the crankcase half (9) to approx. 100 - 120 °C (use industrial hot air gun).

3. Insert the crankshaft (10) with ball bearing (8) in the crankcase half (9).

4. Heat the crankcase half (13) to approx. 100 - 120 °C (use industrial hot air gun)

and press in the ball bearing (8).

5. Place the crankcase gasket (12) on top, center the seal over the clamping sleeve

(x - page 67).