Repair manual

8 Assembly

63 Protective hood/V-belt pulley

9. Set the inner thrust washer (2) and the distance bushing (4) onto the axle (3).

10. Insert the axle (3) into the cutting attachment (19) that is premounted to the hood.

11. Attach the shim ring (16) onto the axle (3).

12. Hold the V-belt pulley (15) against it, block it by inserting a mandrel through the

bore (x) and screw it on with the hexagonal bolt (1) (torque wrench setting

25 + 5.0 Nm).

13. Screw on the handle (9) with the Torx screw (10).

Note: The V-belt pulley (15) is not fastened until the cutting disc is attached.