Repair manual

8 Assembly
62 Protective hood/V-belt pulley
1. Attach the outer retaining clip (13).
2. Heat the cutting attachment (19) to approx. 100 °C (use industrial hot air gun).
3. Press the ball bearing (14) up against the retaining clip (13).
4. Insert the second retaining clip (13) and spacer bushing (4).
5. Also press the second ball bearing (14) up against the retaining clip (13).
6. Apply bonding compound to the fluted area (x) on the screws (20).
7. Insert the screws (20) and stop pin (21).
8. Mount the complete hood (8) with the parts 6,12,11,7,6 and 5 and screw the
screws (17) with springs (18) into the thrust collar (5) (torque wrench setting
10 Nm).
Note: When attaching the hood, make sure you follow the correct order of the
parts (see Fig. 8.1).
19
13
4
13
14
1
2
3
5
6
7
4
2
8