Repair manual

6 Disassembly

34 Recoil starter

1. Unscrew the screws (2).

2. Take off the starter housing (3).

3. Unscrew the screws (11) and carefully separate the air horn (6) from the starter

housing (3).

Note: Always proceed in the order (A - B - C - D).

4. Remove any leftover old rope (13). If needed, release tension on the rope drum.

5. Take off the V-belt (10) and pull off the rope drum (5). Unscrew the Torx tapping

screw (12). Pry the return spring (4) evenly off the latches (y) from the starter

housing (3) by using a screwdriver or similar tool.

Note: Be very careful in doing so.

CAUTION

The return spring is under tension and can suddenly jump out of the housing!

Always wear safety glasses and wear protective gloves when performing this

procedure!