Repair manual

3 Starting up
20 Cold start
3.6 Cold start
• Press the multifunction switch (5) upward (choke position).
• Put your hand around the handle (safety switch (7) is actuated by the palm of
your hand)
• Press the throttle lever (8) all the way through and hold it.
• Press the lock button (6) and release the throttle lever (8) (throttle lever is
locked in place by the lock button in the half-gas position). Press in the start
valve (4).
• Put your hand around the bow handle grip and hold it firmly while you press
the cut-off saw against the ground.
• Place your left foot into the rear hand guard.
• Pull out the starter rope slowly until you feel resistance (the piston is located
before the top dead center).
• Now continue pulling quickly with force until you hear the engine start.
• Press the multifunction switch (5) to the "I" position.
• Pull the starter rope again until the engine runs.
• Once the engine is running, tip the throttle lever (8) so that the lock button (6)
snaps out and the engine idles.
CAUTION
Do not pull out the starter rope more than 50 cm (20") and let it rewind slowly by
hand, not letting it go.