Repair manual

3 Starting up

19 Starting the engine

3.5 Starting the engine

Note: Strictly observe the safety instructions in the operator's manual.

• The cut-off saw must not be started until it has been completely assembled

and tested!

• Take it at least 3 m (10 feet) away from the place where you filled the tank!

• Stand squarely and set the cut-off saw onto the ground so that the cutting at-

tachment is freestanding.

• Move the protective hood (3) to the best position for the application at hand

(see figure).

• Grab the handle (2). The protective hood (3) can be swivelled within the stop-

mounts in both arrow directions.

CAUTION

Make absolutely sure that the straight edge of the stop plate (4) is parallel to the

edge of the protective hood (see arrows).

If this is not the case, please take your unit to the shop.

required