Repair manual

3 Starting up
14 Attaching the cutting disc
3.1 Attaching the cutting disc
Note: Check the cutting disc for signs of damage. See the safety instructions
in the operator's manual.
• Unscrew the screw (9) and remove the thrust washer (8). Set the cutting disc
(5) onto the shaft (7).
Note: The center hole of the cutting disc must fit exactly onto the shaft. You
must use an adapter ring if the center hole is larger.
• Set the thrust washer (8) onto the shaft, screw in together with the screw (9)
and tighten by hand.
• Turn the cutting disc slowly until you can see the locking bore of the V-belt
pulley bolt through the gear arm hole (10).
• Press the offset screwdriver (2) all the way in. The shaft is now blocked.
• Firmly tighten the screw with the combination wrench (1).
Note: Firmly tighten the screw to 30 + 2 Nm (22 + 1.5 ft.lbs.), otherwise the
cutting disc may slip while cutting.
WARNING
If you are using diamond-edged cutting discs, make sure you observe the
attached rotational direction mark!
Diagram