Repair manual

2 Safety instructions

12 Maintenance

2.7 Maintenance

• Before you carry out any maintenance work, always turn off the cut-off

saw (10) and pull off the spark plug connector!

• Check that the cut-off saw is in a safe operating condition before you start

work. Make sure that the cutting disc has been attached according to instruc-

tions. Alos make sure that the cutting disc is undamaged and suited for the

application at hand.

• While operating the machine, try to produce as little noise and exhaust fumes

as possible. Check the carburetor setting.

• Clean the cut-off saw regularly.

• Check the tank cap regularly to make sure it is on tightly.

• Observe the accident prevention regulations set forth by the professional lia-

bility insurance association. Never attempt to modify the cut-off saw! Doing

so will endanger your safety!

• Maintenance and repair work must be carried out only to the extent detailed

in this repair manual. All other procedures must be performed by Wacker

Service.

• Use only original Wacker replacement parts.

• If you use non-original Wacker replacement parts, accessories and cutting

discs, you will increase you changes of having an accident. Any accidents or

damage that occur with non-original Wacker parts will invalidate your warran-

ty.

SERVICE