Repair manual

2 Safety instructions

10 Cutting discs

• When operating the cut-off saw, hold it firmly with both hands. The right

hand on the rear handle, and the left hand on the bow handle grip. Hold the

grips firmly using your thumbs.

• Always ensure that you are standing in a secure position.

• Hold the cut-off saw in such a way that you cannot inhale the exhaust fumes.

Do not work in closed rooms or in deep trenches (danger of poisoning

through exhaust fumes).

• If you notice any changes in the way the unit operates, turn off the motor im-

mediately.

• You must turn off the motor before you check the V-belt tension,

retighten the belt, change the cutting disc, remount the cutting attach-

ment (outer or center position) and eliminate malfunctions (9).

• If you hear or feel a change in the way the unit is cutting, turn off the motor

immediately and check the cutting disc.

• During breaks and after you finish work, turn off the cut-off saw and set it

down so that the cutting disc is freestanding and cannot endanger anyone.

• Do not lay the hot cutting disc on dry grass or onto combustible objects. The

muffler radiates an enormous amount of heat (danger of fire).

• CAUTION: After a wet cutting procedure, first shut off the stream of water

and then let the cutting disc run another 30 seconds so that it can spin off the

remaining water. This prevents corrosion.

CAUTION

When you release the throttle lever, the cutting disc will continue to run briefly

(afterrun)

*Maintenance

*Filling the tank

*Changing the cutting disc

*Remounting the cutting

attachment

*Taking a break

*Transport