Repair manual

2 Safety instructions

9 Cutting discs

• The cutting disc must be approved for freehand cutting with a 350 mm (14")

cutting disc diameter up to 4370 rpm or 80 m/s (260 ft./sec) or with a 300 mm

(12") cutting disc diameter up to 5100 rpm or 80 m/s (260 ft./sec). Use only

cutting discs that comply with EN 12413, EN 13236 or with the BGV D 12.

• The cutting disc must be completely undamaged (7). Test it by performing a

sound test with a piece of wood.

• Always tighten the cutting disc to 30 Nm, otherwise you may distort the cut-

ting disc.

• Before starting, the operator must stand at safe distance away from the cut-

off saw.

• Start the cut-off saw only as described in the operator's manual (8) Always

set your left foot into the handle and firmly hold the bow handle grip handle

by using your thumb. Starting the unit in any other way is not permitted.

• When you start up the machine, support it well and hold it firmly. The cutting

disc must be freestanding.

• A new cutting disc must be tested before you cut with it by running it at least

60 seconds at the specified maximum speed. Ensure that no one is in the ex-

tended swing area of the cutting disc.