Repair manual

10 Maintenance
104 Miscellaneous
10.10 Miscellaneous
1. Cutting attachment in the center/outer position
Note: The cutting attachment is mounted at the factory for operation in the
center position (1). The cutting attachment can be mounted in the outer
position (2) to maneuver around obstacles that are very close to the
cutting line (for curbs, or brick walls). Use the outer position for guiding
the cut-off saw by hand only for the work at hand. Afterwards, mount
the cutting attachment back to the center position. A cut-off saw with
the cutting attachment in the center position has a better center of
gravity, which helps prevent early fatigue.
2. Remounting the cutting attachment
• Loosen the nuts (5).
• Loosen the tension screw (3) (counterclockwise direction) until you see the
screw end (4) in the gap. Unscrew the nuts (5) and remove the cap (6).