Repair manual

2 Safety instructions

8 Cutting discs

2.5 Cutting discs

• The protective hood must always be attached. Change the cutting disc only

when the motor has been turned off!

• If you are using diamond-edged cutting discs, make sure you observe the at-

tached rotational direction mark.

• Cutting discs are only designed to cut materials on their edges. Never use the

side surfaces for grinding purposes as this can break the disc (5)!

Note: It is prohibited to change the direction (a radius of 5 m (16 feet) or less),

apply lateral pressure or tilt the cut-off saw while you are cutting (6)!

• Cutting discs must only be used to cut materials they were designed for. De-

pending on the material you wish to cut (metal or concrete), you must select

the proper disc type.

• The center hole of the cutting disc must fit exactly onto the shaft. If the center

hole is larger, you must use an intermediate ring as an adapter.

min. 5 m

(16 feet)