Product Manual

10 Maintenance
100_0202_mt_0015.fm 31
10.2.7 Replace the exciter oil and check the oil level
1. Tip the machine to the side of the filler boring and support it.
2. Place an appropriate collecting container below the filler boring.
3. Remove dirt accumulation within the range of the filler boring.
4. Unscrew the screw plug from the filler boring and allow the waste oil to drain completely.
5. Tip the machine to the other side and support it.
6. Fill new oil (see chapterTechnical Data for the exciter oil type and volume) into the filler boring. Use
a suitable, clean filling container.
7. Place the machine level on the ground.
8. Screw the screw plug with seal ring into the filler boring. The tightening torque setting is 100 Nm.
DANGER
Risk of scalding
 Use caution when draining hot oil.
NOTICE
Perform oil change with warm exciter oil. The machine cannot be in operation.
Item Designation Item Designation
1 Screw plug 2 Filler boring
NOTICE
Lay an impermeable film on the working surface to protect against escaping oil.
NOTICE
Collect escaping or overflowing oil and dispose of with the waste oil in an environmentally
friendly manner in accordance with the existing rules and regulations of the legislative
body.
NOTICE
Only fill with the prescribed volume of oil.
1, 2