Product Manual

9 Operation and use
100_0202_op_0016.fm 23
9.3 Commissioning
9.3.1 Start engine
1. Turn the fuel cock to ON.
2. Set the choke lever to the CLOSE position.
3. Pull the throttle lever backwards slightly.
4. Turn the ignition key switch to l.
5. Pull out the starter rope slowly up to the compression resistor, and then pull through forcefully.
9.3.2 Commissioning the machine.
When the engine has warmed up, push the choke lever to OPEN.
Set the throttle lever to the desired engine speed.
DANGER
Fire hazard
Jumper cable sprays are highly flammable; they can ignite and cause severe burns.
 Do not use jumper cable sprays.
NOTICE
Do not use the choke if the engine is warm or if the air temperature is too high.
CAUTION
Do not allow the starter rope to snap back against the engine. Slowly guide back by hand
to prevent damage to the starter.
WARNING
Oil level warning system
The oil level warning system should prevent engine damage that can be traced to
insufficient amounts of oil in the crankcase. Before the oil level in the crankcase can drop
below the minimum level, the oil level warning system will automatically switch off the
engine (the ignition key switch remains in the I position).