Product Manual
9 Operation and use
22 100_0202_op_0016.fm
9 Operation and use
9.1 Before commissioning
9.1.1 Inspection before commissioning
Check the machine and components for damage. In the event of visible damage, do not operate the
machine and immediately contact Wacker Neuson partner.
Ensure that loose packaging material has been removed from the machine.
Check the fuel level.
Check the engine oil level.
Check air cleaner.
Check hydraulic oil level.
Check the fuel lines for leak tightness.
Check to ensure the screwed connections are firmly seated.
9.2 Notes about operation
Operation on sloped surfaces
Always stand above the machine within the area of a slope.
Only approach gradients from below (a gradient that can be easily driven up can also be driven down
without any risk).
Do not stand in the direction of descent of the machine.
Do not exceed the maximum allowable slanting position (see Technical Data) chapter.
Only operate the machine for a short time in maximum allowable slanting position.
Vibrating sett paving (paving stones)
When compacting interlocking paving stones, Wacker Neuson recommends using of the sliding device
in order to avoid damage to the machine and compaction material. See chapter Accessories.
WARNING
Improper handling may result in injury or serious material damage.
Please read and follow all safety instructions in this operator's manual.
NOTICE
Perform checks according to the Maintenance chapter. If necessary, top off missing fuel,
lubricants and coolants, see chapter Technical Data.
WARNING
Danger of tipping
There is a serious risk of injury from slipping or tipping over of the machine.
Near edges, at least 2/3 of the machine must be on a load-bearing surface.
Turn off the machine and lift it back onto a load-bearing surface.
WARNING
Health hazard from exhaust fumes
The exhaust fumes of this engine contain chemicals, which the state of California
knows can cause cancer, birth defects or other reproductive damage.
NOTICE
If the maximum permissible slanting position is exceeded, this results in a failure of the
engine lubrication and therefore inevitably causes a defect of important engine parts.