Product Manual
Table Of Contents
- 1 CALIFORNIA Proposition 65 Warning
- 2 Preface
- 3 Introduction
- 4 Security
- 4.1 Policy
- 4.2 Proper use
- 4.3 Structural changes
- 4.4 Areas of responsibility of the operator
- 4.5 Operator responsibilities
- 4.6 Personnel qualification
- 4.7 Residual dangers
- 4.8 General safety instructions
- 4.9 Specific safety instructions - Vibratory rammer AS
- 4.10 General safety instructions – fuel, lubricants and coolants
- 4.11 Maintenance
- 4.12 General safety instructions - Rechargeable battery (accessories)
- 4.13 General safety instructions - Battery charger (accessories)
- 4.14 Personal Protective Equipment
- 4.15 Behavior in dangerous situations
- 5 Safety and information labels
- 6 Setup and function
- 7 Components and operator's controls
- 8 Transport
- 9 Storage
- 10 Operation and use
- 11 Maintenance
- 12 Troubleshooting
- 13 Disposal
- 14 Disposal
- 15 Accessories
- 16 Technical data
- 17 Glossary
11 Maintenance
34 100_0201_mt_0002.fm
Oil change – AS50e
1. Remove dirt accumulation within the range of the oil level glass.
2. Screw on the oil level glass. Clean the thread on the inspection glass and wrap with Teflon tape.
3. Tilt the vibratory rammer backward until it rests on the control handle and the drain the used oil into
a suitable reservoir.
4. Tilt the vibratory rammer forward and secure in this position.
5. Fill oil through the opening in the inspection glass in the housing. For the oil specification, see chapter
Technical Data.
6. Screw the inspection glass back on, but do not tighten.
7. Stand the vibratory rammer upright to check the oil level.
8. If necessary, top off the oil until the inspection glass is 1/2 to 3/4 filled.
9. Then tighten the inspection glass. The tightening torque is 9 Nm.
10.Wipe the area of the oil level glass with a clean cloth.
NOTE
Used oil must be disposed of according to the applicable local environmental protection
regulations.
NOTE
This process can take up to 10 minutes.