Product Manual
Table Of Contents
- 1 CALIFORNIA Proposition 65 Warning
- 2 Preface
- 3 Introduction
- 4 Security
- 4.1 Policy
- 4.2 Proper use
- 4.3 Structural changes
- 4.4 Areas of responsibility of the operator
- 4.5 Operator responsibilities
- 4.6 Personnel qualification
- 4.7 Residual dangers
- 4.8 General safety instructions
- 4.9 Specific safety instructions - Vibratory rammer AS
- 4.10 General safety instructions – fuel, lubricants and coolants
- 4.11 Maintenance
- 4.12 General safety instructions - Rechargeable battery (accessories)
- 4.13 General safety instructions - Battery charger (accessories)
- 4.14 Personal Protective Equipment
- 4.15 Behavior in dangerous situations
- 5 Safety and information labels
- 6 Setup and function
- 7 Components and operator's controls
- 8 Transport
- 9 Storage
- 10 Operation and use
- 11 Maintenance
- 12 Troubleshooting
- 13 Disposal
- 14 Disposal
- 15 Accessories
- 16 Technical data
- 17 Glossary
11 Maintenance
32 100_0201_mt_0002.fm
1. Remove dirt accumulation within the range of the zerk fitting.
2. Apply the filled grease press to the zerk fitting and actuate about 20 times (about 30 grams).
3. Wipe the area of the zerk fitting with a clean cloth.
Check the oil level and top off – AS50e/60e
1. Remove dirt accumulation within the range of the oil level glass.
2. Tilt the vibratory rammer so that it forms a right angle to the ground.
3. Check the oil level through the inspection glass. Oil must fill 1/2 to 3/4 of the inspection glass.
4. If the oil level is too low, top off the oil. For the oil specification, see the chapter Technical Data.
NOTE
Only use special lubricants for the lubrication, see chapter Technical Data.
NOTE
If the vibratory rammer was transported in a horizontal position or was just relocated, it
must be put in a vertical position for 15 minutes before the oil level can be checked.
NOTE
Do not overfill the ramming system with oil. An oil level that is too high can lead to a
hydraulic lock in the ramming system. This can lead to faulty operation and damage to the
ramming system.