Product Manual
Table Of Contents
- 1 CALIFORNIA Proposition 65 Warning
- 2 Preface
- 3 Introduction
- 4 Security
- 4.1 Policy
- 4.2 Proper use
- 4.3 Structural changes
- 4.4 Areas of responsibility of the operator
- 4.5 Operator responsibilities
- 4.6 Personnel qualification
- 4.7 Residual dangers
- 4.8 General safety instructions
- 4.9 Specific safety instructions - Vibratory rammer AS
- 4.10 General safety instructions – fuel, lubricants and coolants
- 4.11 Maintenance
- 4.12 General safety instructions - Rechargeable battery (accessories)
- 4.13 General safety instructions - Battery charger (accessories)
- 4.14 Personal Protective Equipment
- 4.15 Behavior in dangerous situations
- 5 Safety and information labels
- 6 Setup and function
- 7 Components and operator's controls
- 8 Transport
- 9 Storage
- 10 Operation and use
- 11 Maintenance
- 12 Troubleshooting
- 13 Disposal
- 14 Disposal
- 15 Accessories
- 16 Technical data
- 17 Glossary
10 Operation and use
26 100_0201_op_0006.fm
In accordance with the intended purpose, the operator should stand behind the machine.
Guide and steer the machine using the control handle.
Utilize the machine's net weight when working.
Allow the machine to pull forward independently. Do not push or pull forward or backward with muscle
power.
Hold the control handle left and right for optimal control and performance, and minimal hand-arm-
vibrations.
To avoid damage to the machine, the machine may not be relocated in a running state.
Use caution with coarse materials. In order to avoid extreme wear of the ramming shoe, this must
always strike parallel to the bottom to be compacted.
Operation in channels
On pit, cavity, dump and embankment edges, on trench edges and terraces, operate the machine so
that there is no danger of falling or tipping over.
Pay attention to the side walls and their stability. Danger of collapse and burying!
Stability!
Operation below freezing
The cold grease or oil in the percussion system can increase the resistance so much that the centrifugal
clutch slips.
10.3 Commissioning
1. Firmly hold the machine by the control handle.
2. Check that the starter lever is in the OFF position.
3. Press the starter button on the rechargeable battery.
4. Pay attention to the light progress bar. The LEDs illuminate alternating and then show the current
charge situation of rechargeable battery.
CAUTION
Injuries or material damage.
There can be strong recoils on firm, hard or rigid bottoms.
Avoid these bottoms.
NOTICE
The machine must stand upright when starting and be placed on a suitable subsurface.
Item Designation Item Designation
1 Start button on / off 2 LED light progress bar
12